R/C Tech Forums - View Single Post - Mugen MTX-4R
Thread: Mugen MTX-4R
View Single Post
Old 05-23-2007, 06:09 PM
  #135  
va_connoisseur
Tech Regular
 
va_connoisseur's Avatar
 
Join Date: Sep 2005
Location: DC Metro
Posts: 375
Default Anti-Roll bar issue

I was finishing the front end assembly tonight and ran into a couple of issues. The front anti-roll bar appears to be binding/misaligned. Note the photo, the right side pertrudes out while the left side if flush





And now it appears the adjustment screws on the bottom have stripped because I cannot back them out. Any suggestions?

Also, are the pillow balls supposed to be difficult to screw into the upper and lower A-Arm? I could only get them about halfway before it felt like applying more pressure would cause something to strip. I check the alignment and they appear to be going in straight. Thanks in advance for help and suggestions.
va_connoisseur is offline