R/C Tech Forums - View Single Post - Help needed with linkage setup
View Single Post
Old 04-10-2003, 02:14 PM
  #1  
NitroMaxx
Tech Rookie
 
Join Date: Apr 2003
Posts: 1
Help needed with linkage setup

I'm setting up my throttle/brake linkage. I don't know if this is how it should look like but the spring is compressed all the way when I apply the brake and the horn is parallel with the servo(see pic 1). The horn moves about 10mm from idle positon to full brake. That seems too little for me. But it can't go any further because there isn't any room between the spring and the collar.
What am I doing wrong?

Full brake...


Full throttle...


Idle...


Thanks
NitroMaxx is offline