Thread: Xray T2'007
View Single Post
Old 05-18-2007, 08:32 AM
Tech Addict
iTrader: (2)
Join Date: Dec 2004
Location: MI
Posts: 574
Trader Rating: 2 (100%+)

Originally Posted by RobS
I've also had a couple Xray bearings go south on me. Did you clean and re-oil them before you built the car? I think Xray posted on the site a while back that the bearings didn't get packaged with sufficient lube and recommended that you clean and re-oil them to make sure they last...
I assumed it was an issue only on the first batch of kits... I would expect them since they found out the issue they would address it on the newer kits... Or maybe they have bought 200,000 bearings which all have the same problem... If that's the case then they should include the instructions in the manual. Website is nice but not everybody has access to the Net or think about checking it out in the first place.
cvt01 is offline  
Reply With Quote