R/C Tech Forums - View Single Post - Go Tech Engines
Thread: Go Tech Engines
View Single Post
Old 05-11-2007 | 09:12 AM
  #94  
Rookie 4.6's Avatar
Rookie 4.6
Tech Addict
iTrader: (1)
 
Joined: Jan 2006
Posts: 635
From: Adelaide South Australia
Default
Originally Posted by dido41
Soon I will be getting a GO Tech 7+2p Modified motor. After breaking it in, is it a good idea to replace the bearings with ceramic Bearings and should I do both front and rear?
Also should I replace the Rod as well? And how long should I wait to do this?

Thanks
If I were you I would get the ceramic bearings installed when you have the engine modded. None of the guys I know have problems with the rods. I know it will put less strain on the rod if you heat the engine up before starting when running in..
Rookie 4.6 is offline  
Reply