Ok guys I am really confused with how people are listing drop on setup sheets.
I was checking out the setup sheet from andy moore from the worlds. It list ride as 5mm and droop as 5.5mm.
Now when it is listed as 5.5mm for droop does that mean 5.5 mm of uptravel. So when you lift the rear of the car and slide a ride height gauge under the chassis it should read 10.5 mm (5mm ride height plus 5.5mm droop)
or
Is it 5.5 on a standard droop gauge.
or
is .5 mm above ride height of 5mm
I am a little confused as I am primarily a foam carpet guy and you never run more of 1mm or so of uptravel/droop above ride height.
Thanks