View Single Post
Old 05-02-2007, 08:46 PM   #18640
Regional Moderator
Darkseid's Avatar
Join Date: Aug 2001
Location: At my computer, duh...
Posts: 9,033
Trader Rating: 8 (100%+)

Hey Skiddins: I got a hot tip for you that I've been sharing for quite some time over on the TA05 thread in reguards to the kimbrough medium. The one you using is the predrill model. The top hole on that isn't very high when compared to most servo arms.

Here's what you do, get this Kimbrough medium w/o holes. Instead of predrilled holes, it has 'outlines'. And one of these outlines is in the middle, but its up above the hole that your currently using.

If it will clear the upper deck, this should get you pretty much back to the original throw the car was intended to have with the kit arm.

Take a look at the pic I've attached and see how much higher the mounting hole is.
Attached Thumbnails
Click image for larger version

Name:	servo saver.jpg
Views:	157
Size:	77.5 KB
ID:	227370  
TLR 22...Tamiya F104...
Darkseid is offline   Reply With Quote