Well my Hellfire SS Kit came in today. In the thread I started before I found this one I stated I am planning to do a brushless lipo mod to it. But for now I am going to run it as intended with a nitro engine. Since I never owned a nitro I figured why not give it a try. So I ordered an LRP v3 2.8 for it tonight and it should be in on Monday. I have to stop back and order a Futaba 3PM 2.4Ghz. I think I am going to go with the JR Digital servo they stock, it is 200+-320tq and 1.8-1.5 for speed depending on the pack you use (I think). I have a few basic Futaba servos around that I hope will be good enough for the throttle.
Anyway I just wanted to say thanks to everyone in this thread for all the great advice and setup tips. And yes I got the Hellfire because it was so cheap.