Originally Posted by BRENDAN LUGO
Can you confirm that the frequency crystal in the module of the transmitter is the correct crystal for that module/transmitter setup?
Yes, it is a KO Propo single conversion crystal set
Originally Posted by BRENDAN LUGO
If it is correct then the transmitter should be working with the receiver. Do you know that this transmitter even works properly?
It worked perfectly before I swapped the rx into another car and shorted it out when plugging in a battery pack wired for futaba. It was an airtronics rx.
Originally Posted by BRENDAN LUGO
Do you have the KO receiver to test the transmitter with? There could be a problem with the transmitter not putting out anf RF in which case you need to sent the radio to KO to have them check it out.
No I do not have a KO receiver and I don't want to spend over 100 dollars to get one for a 10 year old radio. A friend of mine has a FM frequency scanner which will show what frequencies are in use. I can test the tx with that to see if it is working. I will keep you posted. Thanks.