Originally Posted by odpurple
i finally found the time to finish a project I've been working on since last year. It's a hybrid car with a BMI motor box and OD12 front chassis. Jason sent me a top plate along with the motor plates so I could get the spacing right. I decided to use his top plate and made a one-off bottom plate to hook the two ends up. The BMI graphite has a nice satin finish, and my stuff is the usual shiny cf, so I wet sanded the OD12 parts to get a matching finish on the whole car. I sanded the parts surfaces after sealing the edges with ca so it has a really nice look to the edge. I'm really happy with the way this one turned out
Oh that's it. You told me my red conversion was going to be slow and you even have red clips?