R/C Tech Forums - View Single Post - Novarossi engines thread
View Single Post
Old 04-13-2007 | 02:34 AM
  #2036  
Sirio2127's Avatar
Sirio2127
Tech Regular
iTrader: (1)
 
Joined: Jun 2005
Posts: 379
From: The land of two heads
Default

Hi Delta9, You defenatly made the right choice. You sound like you maintain your engines well I don't realy do anything special to any of my engines to make them last. Just after evey time i'm finished useing them i remove the exhaust system and air filter box and cap the engine with dust caps. I then remove it from the chassiss and spray the out side with some methlated sprits in a spray bottal and dry useing an air compressor. I then remove the back plate inspect the conrod and bearings. I use novarossi after run oil and make shore the engine is well oiled i don't skimp on oil. I then replace the backplate and seal the engine in a zip lock bag and put away and till i use it agen. The night befor i am due to use it i will take it out remove the carby and exhaust caps and drain the excess oil throught the exhaust port. That takes a cupple of minets to make shore that the engine dose not get to much oil in the cylinder when its first started after storage. Good luck Best regards Jeremy.
Sirio2127 is offline