Originally Posted by mxwrench
MRX4,
By the way, in EB's defense, He is pretty serious about his craft and he recently added an Xdyno to his line of equipment. I expect very good things from him in the near future.
BK
Mxwrench as eb quoted this cannot be done over night!
Each engine that comes from EBMods is fully mapped out. The process of which everything is measured, mic'ed, and cc'ed. These numbers are then compared to the original R&D engine specs, to make sure that no running production changes were made at the factory. If a simple timing change is made at the factory then these calculations now need to be readjusted on the engine blueprint, and noted. This insures the highest quality control. What we do at EBMods can't be done over night.
I guess this is where he balances the crank, I guess he did touch the crank.
He is correct this cannot be done overnight he made 100.00 in ten min..