Originally Posted by Bob-Stormer
I'm in. I'd take a few sets. See if you can make a 3.25 or 3.5. Not sure if there is enough room before the axle bottoms out in the tube. As is, with a 3.0 adjuster you have to pretty much toss the rear tire at 40.5mm
You wanna be a hero? Re-design the front suspension bridge so it won't bend like a twig (and put another degree of caster in it). I realize that something else is going to bend in place of it, but I'm okay with that.
After a little checking a 3.25 is the max. That will leave about .1mm between the axle and the tube. Here are the sizes I'll be doing. 0, .5, 1.5, 2.5, and 3.25.
Don't think I want to tackle a project like that bridge but it sure would be cool to do some out of titanium.
Chris