Originally Posted by syndr0me
There's two metal washers (A3253) that are supposed to go on either side of the layshaft between the bulkhead and the pulley. I can't seem to use one on both sides, there's not enough clearance. Is there something I'm missing that I should be looking for? Without the second one in there, there's a little bit of play from side to side. If I force it, it binds up the layshaft.
I had to dremel the PRS spur gear adapter a bit to make enough room for the pin. It seems to be slightly longer than the groove in the adapter. Just a heads up for anybody planning to use that part.
i use the PRS adaptor and did not have to break out the dremel and everything fits fine - will recheck
edit - s/b 2 - 4mm x 1.3 alum spacers