OK, as promised, pictures of Chris's car with the CGM steering modification.
Some quick intructions on how to do this mod:
You will first need the CGM bellcranks, part no SD202G, cut the smaller side off.
Insert the bearings at each end (kit bearings) and screw the ackerman plate to each of them making sure that they face in towards the centre of the car.
Using the standard Yokomo castor blocks and steering spindles you will need to have the balljoint in the 2 hole from the back on the ackerman plate.
Put the completed assembly on the car, place the 0.5mm spacer on top following by another 0.25 spacer and then the blue spacer that normally goes underneath.
Screw the top deck on, job done.
Remember to check toe in.