Originally Posted by InspGadgt
Depending which car you have your front axle will either have a nut threaded on the end or use an E clip to hold the wheel on. If using an E clip make sure to shim the wheel so that there is only a slight amount of play between the bearings and the E clip. But more reccomended is to get an aftermarket axle which uses a nut to hold the wheel on.
For the rear wheels if the bolts don't reach the hubs then you probably used the wrong bolts elsewhere on the car.
well the screws that came with the kit were the only set to come with 6 screws and the instructions indicated that they were the right ones just too short, and are the bearing suppsoed to fit inthe front wheels or jsut fint on the outsides?