Originally Posted by Scottrik
Gotta be careful, though, trusting that the IRS lowered arms are even. I was working on the assumption they would be even because they are machined but I found that I had a .020" difference side-to-side. I'd have figured there was something else at play, but it's been the case on both my current 3.2R's AND my Darkside. That's a small enough difference, though, that taking them down the last little bit was easy enough to do without creating additional problems (changing camber/caster, etc).
Scottrik
How do you check the hgt's? I set mine up in a verticle mill and still have different heights some times. I then us shims to get them level. Once this is done, I can add shims to both sides to get the ride height that I'm looking for.
Grenade