Originally Posted by cfwdude
Brian,
The mamba 25 is spec'ed for 2-3 cell lipo, not 1. There is no low voltage cutoff that you can set for one cell. You can always turn off the LVC, and hope you don't get too discharged.
You may as well just use a 2cell pack, just get a smaller one if you're concerned with wieght. a 2cell 900mah lipo is only 40g. hell, if you're not worried about ROAR rules, just put in a small 3 cell.
I've run a mamba 6800 in my T-fource. someone makes an adapter plate to bolt the little thing right in, but I just used one screw. Worked ok till i hit the wall.
Plenty of power on these little motors. It was faster than a 19t, but laptimes sucked since it wasn't setup for the change in wieght distribution.
plate is made by BK Electronics in Germany
http://www.finedesignrc.com/ is the U.S. distributor.