i have been checking out my throttle servo as preventative maintainance, just wanting to be sure that i have every thing set up as close to perfect as possible. i used the post by Steve Walters on page 43 of this thread as a guideline but i do not have the extra travel on the carb at full throttle. when full throttle is applied and you pull on the carb slide to get any extra movement it is already at full open. i have my epa set to barely get full throttle yet i do not have any free play on the carb slide when at full throttle. is that absolutely necessary, and if so how do i get more movement out of the carb slide?
i have not had a servo failure but would like to have it set up correctly if possible.
this is controlled by the carb not the linkage, correct?
thanks