Originally Posted by TRFMAD
Hi Guy's
Again, I am a knob and need to know a couple of anwser's on the MRE/MSX issue I have please.
Okay here I go.
Say you guy's that have a MRE and want to run the MRE one way. What do you do with the direct centre shaft and fixed TA05 pullleys. Do you change the centre unit over and if so to what?
Do the TA05 pulleys last longer or shorter and are they more efficient.
Also is the MRE top graphite chassis the same as the MSX or different.
Any help would be great.
Thank's again for all your support with my enquires.
Addam
Hi Addam,
IMO, To run Front and Center one-ways on MRE, you will need to get the Front MR One-way housing unit and for the center one-way you will either need (i) use the entire MSX-center shaft one-way system or (ii) get the TA05's center shaft, pulleys, spur holder n TA05 center one-way then add shims & modify from there to fit, OR best -(iii) wait for the MSXX system.
(hmmm, I remembered I posted this question some pages back, BTW, I think the Guys have advised to use the MSX system)
Top decks of the MRE and MSX are different at the steering crank position.
The plastic TA05 center pulleys have been on my TA05 for 9-10 months without much signs of wear.
Cheers