Originally Posted by Sp Racer
Front -
Dark blue spring - kit piston - 550 oil - 11 ackerman - spool - roll center "B" up - carbon shock tower mounting 1st hole in from outside - caster in the middle - 1.5 deg neg camber, 2 deg toe out - swaybar full flat ( softest)
Rear -
Dark blue spring - kit piston - 500 oil - camber link mounted lower inner hole - 2mm spacer outer - roll center "B" up - shock mounting 2 holes in from full vertical - either blade sway bar full flat or black wire sway bar - rear diff 30k filled to the spider gears - 4 deg neg camber, 3 deg toe in -longer rear universal joints were used without the 2mm axle spacer (allows the use of 2mm offset wheels) - 23 t side pulley & 2mm split - 58/56mm tyre diameter
Sirio STI gearing - 17/61 ~ 22/55 - 0.9mm spring pre load, 0.6mm clutch end play
hope this helps!
How did you like the feel of the clutch engagement moct of the time I am using a.4 or.5 depending on the track with a 1.2 pre load
tip also low traction track 10,000 diff