R/C Tech Forums - View Single Post - TC3 Forum
Thread
:
TC3 Forum
View Single Post
02-26-2003, 10:04 PM
#
4179
James Nguyen
Tech Fanatic
Join Date: Jun 2002
Location: Modesto, Ca
Posts: 991
Trader Rating
: 0
I put the IRS drive cups on last night and tightened the screw down on the input shafts (also IRS) and there is back and fourth movement along the shaft (not side to side). Is there something you guys are doing to make the cups fit better?
Reply
James Nguyen
View Public Profile
Find More Posts by James Nguyen
View iTrader Profile