Originally Posted by MR JOLLY
but then if we can get a good can heat sink this in turn will keep the motor cooler longer & no Motor fade
can/mag get to hot = motor fade
just remember this
there is a Plastic Endbell between the can & brush/comm & i have allways taken measurments from the can & not the arm through the can vents (as this gives you a false reading), so i`ve been told & taught
so if get the can to dissapate more Heat quicker then this in turn will keep the comm/brush cooler ??
Just curious, why does measuring the arm temp through the vent holes give a false reading ?
Thanks.