Originally Posted by flying G.E.O.
you guys have a better idea how to use a carbon lipo with the mo3? I had to run my wires from below since the battery ports are covered if on top. A bit scary the wires might scrape the ground.
I'm guessing you're using the quick release battery holder. You can't. Put one of the stock plastic body pin type ones on the side where the wires are. You'll have to trim the area where the holder makes a 90 degree bend to give the battery more length room.
If you're having rolling over problems using the Lipo its because the battery is too light. The minis need the extra weight to keep it stable.