hi,
either i'll modify these ones or the next 4 being made will different.
i could not get counter sunk screws from the screw shop in the length i wanted as i had to buy specialty screws for this job. I dont think it will really matter if racers scratch the chassis a bit cause you tend to ALWAYS scratch it from running it and racing it
A non-slip foam surface on top?
i dont see how your going to get it in that shape around the whole alum plate and that kinda defeats the purpose of the BLING-ness and durable-ness of the item
rubber feet were a tiny bit hard to do since the area on the bottom of the screw s is like less than 5mm so rubber feet would most likely just fall off, but i have been told of some screw on rubber feet and i am currently investigating that.
thanks for the comments!