i dont have a camera handy but i will when i make my new pieces for it . it looks rough because it was for testing and was made out of kydex. pretty much it is a triangle piece that bolts to the swaybar holes in the topdeck and a center hole i drilled that put the bellcrank back enough to clear the diff pulley. i used xray captured ends for the links but i think that the stock ball cups are a better choice as i had to take a dremel to the captured ends so it wouldn't bind. and i made extensions that made the new knuckle hole 6mm back. this gives it the angle pretty close to the xray cars. i think that this would work better than actually using the corally one because you use the stock steering post with a 3mm spacer under the adapter so you dont worry about belt clearance.and you can use the 3.4mm regular topdeck which is stiffer.