Originally Posted by uniquexme
all rite, since u guys said that its so easy, i shall give it a try this week. hope it work out. but may i know wat tools i need so that i can get it today.
Desmond, if you need assistance, I mention before that you can pm me your number and I can call you since we are on the same time zone.
This mod is easy unless you have not used a "file" before.....
so dont tell me
Again, only a prevention. I have been running these crankcase without mod and all require is you tune the bottom needle properly, on the leaner side if you compare to other brand. It leave oil residue after run but it wont affect tunning or performace. The good side the front bearing will last lot longer.