Anyone know if the MIP clutch, is tuneable with the pins like the other MIP clutches? It does'nt look like it, it looks like it only has one hole for tuning instead of 3.
NTC3NUT: What was the length on the Lunsford turnbuckles you made those with? 1.175? and are they 3mm diameter buckles? Or 3.5mm? I used Ofna captured ball ends with Serpent #1648 short ball ends. You have to file the ball ends out alittle, so the #6 srew will fit through them. I used some 1/8th scale buckles I had with a different thread and I have had no more compression problems, but your way, the turnbuckles are screwed all the way in, so no compression, Right? I used allen head Stainless screws with #3 flatwashers instead of studs and nuts.
You guys will have to use ball ends with a short shoulder on them like the #1648 Serpents, or space the captured ends up some to get the correct travel you'll need.
Last edited by bbntc3; 02-17-2003 at 10:10 AM.