Originally Posted by CarbonJoe
Hi All -
I'm getting a lot of push on right handers only. Turning left is no problem. I have checked the tweak on a tweak board, and it is spot on. I have also verified that the servo travel gives the same steering angle both left and right. The tires have been swapped left/right in both the front and rear, and are within .001 of the same diameter. This is on a 12L4 with .020 front springs, stock shock spring/oil, and the .075 T-bar. Running Parma purple fronts, and I tried both pink and gray Parma rears. Paragon on inner half of each front, all of each rear. 3.5mm ride hight front and rear, batteries back, CO27 motor, 1.83 rollout on high bite CRC fasttrack carpet. Any ideas on how to cure this? Maybe the diff is too tight?
CJ
check that both of your lower front arms are the same height at the pivot ball.i have had some of the front ends be .5mm different left to right which will screw things up.all you will need to do is sand them into allignment.also make sure that you sand the mounting surfaces of the arms because they are not in line with eachother front and rear.this will twist the chassis when you screw the arms onto the chassis.