Originally Posted by GK
Get one of these sanding drums from Home Depot, put it in the drill, you'll be done in 10 min.
Naw I just use this
http://www.amazon.com/IRWIN-12411-Sp...1?ie=UTF8&s=hi
on my drill press with a preset depth. Works perfect and if you are looking for a little lower you can set the drill press with 10* tilt...
Just make sure you setup the drill press perfect first, then if you have one use a vacumme to not get all that CF dust in your nose...
Do all the strat sections first then just a 3/4 inch drill bit in the corners.
Looks pimp...
When my EU T2'007 get here I will post pics...
-Shookie <><