R/C Tech Forums - View Single Post - Prototype: Brush Hood Alignment Tool, Thoughts?
Thread: Prototype: Brush Hood Alignment Tool, Thoughts?
View Single Post
Old 02-10-2003 | 05:34 AM
  #43  
Kraig's Avatar
Kraig
Super Moderator
iTrader: (81)
 
Joined: Aug 2001
Posts: 7,015
From: Sun Prairie, WI
Default
The only hold up right now is the price. I want to keep it as low as possible. The actual alignment bar will have a lifetime guarantee against defect from manufacturing and material defects. Basically I tried to break and bend the prototype I have here and I didn’t have any luck so if something happens to yours I will be in awe and will most likely replace it.

I will probably know more later on today and I will post the dimensions as well.
Last edited by Kraig; 02-10-2003 at 07:46 PM.
Kraig is offline  
Reply