R/C Tech Forums - View Single Post - hpi procced?
Thread: hpi procced?
View Single Post
Old 10-24-2006, 08:19 PM
  #4  
corallyman
Tech Elite
iTrader: (101)
 
corallyman's Avatar
 
Join Date: Feb 2002
Location: Edmonds, Wash
Posts: 4,707
Trader Rating: 101 (100%+)
Default Proceed

I was hoping for more direct questions but here goes. Yes its fast. It handles very well also. Gearing normally for a typical 1/8th track it is as fast as any car out there. It was designed by a very qualified designer who did a great job. The design is quite a few years older than the newer designed cars like the MRX-4R or the serpent 960 or kyosho. In the right hands it is still a great car. Dave Campbell and Ted Hammer and Brent G. made the cars look great when they supported the Proceed through Delta Mfg. I am not sure what part support is like now however. Delta now supports their own car which is based off of the kyosho car.

Steve
corallyman is offline