Originally Posted by _cyclops_
Should fit with some dremel work. The left nudge for the pulley screw is more to the left or right....
which part of the shaft that i need to trim it off. It looks compatible to 710 at the way it looked. i just need a confirmation before purchase this part.
Originally Posted by _cyclops_
The 16T is to 'small' to manufacture. It's adviced to not use it. Some drivers also complain that it will not give more bottom speed because you'll only generate wheelspin.
I'm not sure, but i've heard that the 16T being to small to manufacture with good quality and durability. It's the reason why the 720 changed it's ratio a little, so you don't need the 16T anymore... but i'm not sure...
It looks good with 3porter. just because of thie little problem else it will be perfect.