View Single Post
Old 02-04-2003, 01:54 PM
  #6017  
AMGRacer
Tech Elite
 
AMGRacer's Avatar
 
Join Date: Oct 2001
Location: Brisbane, Australia
Posts: 3,939
Default Re: MTX-3 Rear Setup

Originally posted by rskoncepts
Sorry to change the subject...
Has anyone had time using the MTX-3 rear setup and come up with suspension settings? Compared to my original GRP foam car parts, I had a little more slide in the rear but it was stable and controllable. Tire wear was good in the rear.
I use the lower kyosho holes in the bulkheads and 2.5mm shims under the camber links. This definately removes some of the enrty and exit rear grip from the car when compared to the stock V1RR hubs (i suspect because the car does not roll as fast) but mid corner grip in high speed sweepers is sensational. You need to find a balance between entry grip and mid corner grip.
AMGRacer is offline  
Reply With Quote