Originally Posted by bigair78
Anyone having any trouble with the steering throw.
How tight should the belt be? The factory settings seemed to tight and made alot of noise.
I loosed the rear belt a bit by turning the mounting ring around the diff so the notch was facing backwards. After a few runs the rear belt loosened up so i moved them back to face forwards.
With the steering throw check that its not binding at the centre post where the servo saver is. Disconnect it from the servo saver and check that its moving smoothly. Also i found that mounting it on the top hole of the servo horn was making the steering bang hard up against one side of the bulkheads. Ive dialed out the end point on one side of my controller as i dont think this can be a good thing for the servo or the handling.