I just bought a new 12L4 and I was going to install the motor and I can not get it to fit correct. I can get in the pod area but when I tighten or try to tighten it down I can not get it to set correct. I am using a CO2 motor and I have no idea what I am doing wrong. It looks to me that the holes in the plate do not line up with the motor and the motor is hitting the T-Plate. I am using a 64 pitch 35 tooth with the stock spur gear. Is the motor can to big? I have been out of the hobby for over 3 years and I never had this problem with my last 12th scale. Did something change in the past 3 years? Can anyone give me ideas on what to do. Thanks!