Hey all,
I am currently running a novak explorer II speed control with my JR XR3 radio on a SC18 car. When I go to set it up, the throttle works fine, but I don't get any breaks. When I go to use them, the light goes out but it doesn't start showing green like it says in the manual. If I however reverse my throttle setting (basically like a servo reverse switch) my breaks do come on but then everything else is not right, at least though I know that the breaks do work.
Is there something I am not doing right when setting up the radio to work with the ESC? I noticed that I couldn't get breaks to work on my cyclone with this radio unless I had at least 30 set on the BRG when using the A thumb button to set it. I have tried this on the BRP car, but it doesn't work, Any ideas?
Thanks.