so, i had a pretty good day of racing today. my new stiff setup for my track has my buggy hooked, lots 'o traction and more steering with a different diff oil setup. however, my day was cut short by a glitching steering servo. i've had it for a year and no problems, so i guess it finally crapped out. it was probably underpowered for the job, a hitec 5625. .14 seconds at 140oz of torque. not to mention my throttle servo (which is still fine, but underpowered) is .15 at 95oz. i'm going to snag the servos from my truggy and go ahead a do a full on servo change. my options for steering are a hitec 5945 (.13 at 180) or a hitec 5645 (.18 at 165). i'll probably use the 5945 for the steering cause it's faster, but do you think the 5645 is too slow for throttle if i'm used to .15 seconds instead of .18? will i notice a difference in speed? thanks for any help