R/C Tech Forums - View Single Post - Mugen MTX-4
Thread: Mugen MTX-4
View Single Post
Old 09-19-2006, 04:01 PM
  #6157  
wallyedmonds
Tech Elite
 
wallyedmonds's Avatar
 
Join Date: Jul 2006
Location: Brampton ont canada
Posts: 3,662
Default

Originally Posted by Slo-MTX4
But a harder spring wont allow the chassis to roll as much creating less grip there fore less chance of traction roll. And yes the track is a high speed track hence the reason you would use the 4mm chassis.
you would think that but thats not how it works,on high grip and if your a ok to good driver go with 4mm mugen 1st then kanack chassis and a lighter spring will help in not to traction roll the springs the mugen guys allmost allways run is the light blue and there light,if you go to a heavier spring it will traction roll cuz the car has no side movment or not enuff,think of a family car it roll side to side alot,now a M5 its a more sporty car that can corrner a lot better and has less side to side roll BUT and iv seen this if you put realy realy hard springs on it the car can and will roll over now the family car is easier to drive and the M5 needs more attention to drive and the one with the realy hard springs you need 2 hands on the wheel at all times.
wallyedmonds is offline