hey guys looking for some help here. i put together my mtx-3 the other night and havnt gotten a chance to run it yet. and i might this weekend. so i just plan on tweaking the suspention and all the stuff. but it seems a little hard to adjust the camber and all of that. i was just wondering how all of you guys adjust it since there is only a hole there and i dont really have anything that small enough that i can jsut keep spining it to adjust it. and i was wondering if some one could give me a basic set up to use. i have had an R40 for a few years now and i was just going to use kinda the same set up with -2 rear and -1 front camber....1 degree toe in rear and 0 front with a ride height of 6mm. any help would be great.