I dremeled out my chassis to move the batts closer as alot of people have done, however i have a few questions:
-i couldnt get the cell furthest back as far in as the others, since i would of have to dremel alot out of the bearing support thing on the spur gear shaft, is it okay to do it?
-i was using the foam that HPI includes with the micro to keep my batteries from moving outside, however it wasnt thick enough, what are people using to keep the batteries in?
-Also i dremeled out a little bit of my motor opening on the bottom, just like a few mm's on each side, i want to do more, but have people had problems with the chassis warping or anything running mod? also i saw josh cyrul dremeled out his motor clamp to allow air to pass through, anyone else tried this? know if it works?...
thanks!