Next week starts our carpet season here. I'm putting the finishing touches on my new Hyperform Razor. I figure a good starting setup would be similar to what I was running on my 12L4 (that was dialed) for our track. Please shoot any holes in this or give any suggestions you think might help.
10* Dynamic blocks Spaced in the middle
.020 springs
Servo Flat on chassis, turnbuckles shimmed level
.073" T-Bar
35wt oil and AE Silver Spring
CRC Light tube lube (I was using 90wt oil on the damper plates in the 12L4)
Batteries Full Rear
4mm Ride height front and rear
Purple Parma Tires up front
Double Pink Parma Tires in the rear
Protoform Speed12b Body
Co27 with a rollout around 1.85"
96t spur
The only real change from the 12L4 to my new Razor is the chassis and the tubes instead of damper disks.