Originally Posted by ryan6682
ok so motor runs good but is hard to start. is it hard to start the first time when its cold, or hard to start when it is hot. How old is the motor. does it show any sign of a front bearing leak.
if its hard to start cold . is it flooding or not getting fuel? richen or lean the LSN as needed. also be sure to run the motor out of fuel and use just a little after run oil . this make allot of difference in restarting esp if your killing by plugging the pipe and flooding out the motor.
Doesnt matter wether hot or cold. The motor has barely had 3 litres through it and is only about 4 or so weeks old. Front bearing is fine compression is great. I have tried leaning and richening the LSN makes no difference. I have found that on my starter box which has inbuilt glow igniter that the power wire was only hanging on be a few strands and have now rewired and soldered all power wires so fingers crossed this was the problem.
jfc, the plug is a medium however i will get some hot ones and try them also.
Thanks for the input guys its such a shame that this is happening as this motor is a dead set rocket.
Cheers Dan