Since Joven probably already forgot the setup I was using hehe
and Izzy was curious to what it was, here is what I did:
Track: SoCal Raceway, Huntington Beach, CA / Banked Oval into Infield Section
Temp: ~70F
Surface: High Bite Ashpault
Tires: Sorex 36R
Inserts: HPI Green
Wheels: Tamiya 0mm Offset Dish w/two holes drilled
Motor: Monster
Gear Ratio: 96/34
Batteries: Sanyo HV
Front
Camber: -1 degree
Kick-Up: Standard (0.7mm front 0mm rear)
Toe: -0.25 degree each side
Susp Blocks F/R: AA
Wheelbase Spacers: Standard
Ride Height: 5mm
DownTravel: 1mm
Springs: Yellow
Shock Oil: 50W
Shock Position Top/Bottom: Oustide/Standard
Stabilizer Bar: Yellow
Camber Link Positions: Standard
Rear
Camber: -1 degree
Antisquat: 0 degree (2mm spacers under both susp blocks)
Toe: 2.5 degrees
Susp Blocks F/R: AB
Wheelbase Spacers: Standard
Ride Height 5mm
DownTravel: 5-6mm
Springs: Yellow
Shock Oil: 50W
Shock Position Top/Bottom: Outside/Standard
Stabilizer Bar: Yellow
Camber Link Positions: Standard
I'm sure I'm missing something but this should help.