R/C Tech Forums - View Single Post - EAMotorsports discussion thread
Thread: EAMotorsports discussion thread
View Single Post
Old 08-16-2006, 05:51 PM
  #4597  
POOKYT
Tech Elite
 
POOKYT's Avatar
 
Join Date: Oct 2002
Location: Cabot, AR
Posts: 3,584
Default
Originally Posted by maxepower
Hey Eric,

Wish you were out here in Tamiyaland USA. so you could help figure out these 23 turn motors for us. Their the Tamiya RR chrome can motors. Torque motor!
Ran "F" brushes and red springs all around and the motor had plenty of rip but after looking at the brushes they were getting discolored a bit from the heat.
Motor coming off hot! Close to 200 F. Running 5.4 FDR. I may wan to back off a little bit just to save the motor. Any other suggestions would be appreciated!Thanks!
Max

Guys, you may want tot try and take a little off of the trailing edge to reduce the amps and lower the heat a bit. Eric and I did this on our KD's 2 weeks ago and it really helped. Good Luck.

Brant
POOKYT is offline  
Reply