Well I put the front alignment plate back on tonight and it is a no go.If the front plate is off then I have plenty of contact but when it is on and the car is pushed all the way down on the wheel it just barely hits the wheel but not enough to turn over the motor.I am not sure what the deal is but I know that I will not go race until I have these few issues fixed.I know that if I flame out at a race and some pit guy(that I don`t know) is there to help me he will not be able to easily get it lined up and started.Not sure about the throttle/brake linkage either.When I was at the track and hit the brake full and let off the little slider that is on the shaft on the throttle side would stick just enough to pull the throttle out enough to make it creep forward pretty good.This to me is not acceptable because when I enter a corner I will not have effective braking therefore I will push in a corner initially.