Originally Posted by NiMo
I have 1 24T Kfactory pinion, does nothing but strip gears in under 5 minutes, tried another one and have since run 2 meeting with no gear wear, so if you're too stripping gears then I'm wondering if Kfactory released a duff batch?
I don't know...... , but I'm using Kfactory 20 & 25 pinions without problem. I suspect gear mesh problem that would result in stripping gear. Make sure you add all the shims inside the bell ( between clutch spring's locknut and bearing ) and leave the gap or play to minimum for the clutch bell.
The best gear mesh I think is 19 & 25 with stock spur gears. Every gear's tooth seems to match perfectly.