R/C Tech Forums - View Single Post - Ofna Hyper8 stingray
View Single Post
Old 07-21-2006, 07:40 AM
  #390  
tex1
Tech Master
iTrader: (4)
 
tex1's Avatar
 
Join Date: Jan 2005
Location: Dallas, Texas
Posts: 1,156
Trader Rating: 4 (100%+)
Talking New car build....

I'll just highlight some of the things you should consider while you are building.
1. place 1/8" spacer under the outside of the steering linkage and locktight the screw.
2. Shim the servo saver post. They will be very sloppy in the kit.
3. shave the middle nipple on the right side guard. It will hit your throttle servo.
4. Be ready to do the 4mm screw & nut modification on the wing. Every one I have seen has pulled out.
5. Make sure your motor does not hit the chassis or you will break the motor case.
6. Get some stiffer springs.
7. Might want to put an Xray tank in your box as a back up. Every tank has broken here in Texas.
8. Take your droop screws out and grind them flat so they do not dig into the chassis.
9. Get you a long Steering servo horn to get max steering.
Have fun,
TEX
tex1 is offline