R/C Tech Forums - View Single Post - BMI Xray, Hitec Lynx 3D, Integy Charger
View Single Post
Old 07-18-2006, 05:08 PM
  #1  
WVRedNeck
Tech Apprentice
 
WVRedNeck's Avatar
 
Join Date: Sep 2004
Location: Ona, WV
Posts: 70
Default BMI Xray, Hitec Lynx 3D, Integy 16X5V6

I am upgrading my stuff for this season and need to sell off the old to someone else that can use it.

1) Xray T1 Evo2- I ran the chassis twice last season(carpet only), has one small Dremel mark at the front screw of one of the rear bulkheads, other than that it is perfect. BMI chassis, low ratio pulleys, aluminum front 6* C-hubs and steering knuckles, Raycer bulkheads(same as Evo2 but polished), front swaybar, diff and oneway, few pairs of springs and a few extra parts. $235.00




2) Hitec Lynx 3D 75 MHz FM 3 channel radio- 3 sets of crystals, and a 2400maH battery pack. Still has the plastic over the screen. $130.00



3) Integy 16X5V6- specs HERE
You WILL need a 12V power supply to operate the charger. $95



Paypal only.
Email- [email protected]

Last edited by WVRedNeck; 07-20-2006 at 12:35 PM.
WVRedNeck is offline