Originally Posted by fastrcracer
Just got my new wasp installed into my RRR and started to break it in this weekend. I left the box settings on the motor and head shims as it came. I live in Louisville, Kentucky so the temp here has been in the 90's with high humidity. I was using the glow plug that came with the motor, a #6. I run 20% Trinity Platinum fuel with the RD Logics 6505 pipe. I couldn't get the motor to run at any lower than 230 degrees. The stock settings made the motor run very lean and I had to richen both the top and bottom to bring down the temp. Now the bottom end has a real bad bog after sitting for more than 5 seconds. After it cleans out it runs great, but no lower than 230. Any help would be appreciated !!!!!
RTFM!! The manual say the operating temp is 257 deg F and thats what I run at. What % nitro you using? Mine bogs badly with 16% so I use 25%. I have removed 0.1mm shims and screwed in the middle needle 1/8th.
Cheers