Sorry for the quality of these photos, but took them with a webcam. The chassis on this car is not the stock 10LSS. I'm not sure if it is a composite/graphite chassis or a black fiberglass chassis. I do have a graphite top motor plate and the bottom is the stock aluminum. The chassis cross brace is fiberglass. I believe that is was designed for a Velo or high speed track. The Chassis is 7 3/4 inches wide, has 6x6 battery slots, and is 2mm thick. Right now I have old cap tires on it. With cap tires the rear is 7 1/4 inches wide (with narrow rears) and the front is 7 1/2 inches wide. On most 190mm bodies, the chassis should fit under the body. However if you are running at high speed tracks it seals off the underside nicely (if you tape off the chassis). The battery slots are as close to the center line as possible, so it could make a decent onroad car if you want to use it that way - but on old school pan cars wider is better for onroad
Let me know if you have any questions.
Last edited by IndyRC_Racer; 07-14-2006 at 06:51 AM.